Force10-networks C-Series Manuale Utente Scaricare il pdf (Pagina 3)

Caution: Unlock the levers before inserting the line card into the chassis. Fully engage the

locking mechanism once the card has been inserted; not doing so will cause damage to the card

below when that card is inserted.

Warning: Elect

rostatic discharge (ESD) damage can occur when components are mishandled.

Always wear an ESD-preventive wrist or foot-heel ground strap when handling line cards. Place

line cards on an antistatic surface when they are not installed.

101-00310-01 3

Step Task

1 Extend the left and right card levers by first pressing gently down on the thumb tabs (see Figure 2) in

the ejector levers and then pulling the ejector

levers simultaneously until they are in the open

position. See Figure 3.

Figure 2 Depress the thumb tabs

Figure 3 Extend the levers

2 Hold the card assembly by the metal carrier edges. Avoid touching the printed circuit board and

connector pins.

3 Align the card with the guide, and gently

slide it into any line card slot until the card is about halfway

into the slot.

Installation Notes: Use the markings on the fan tray to determine which slots are for the

RPMs and which are for the line cards.

1 2 3 4 5

Nessun commento

Force10-networks C-Series Manuale Utente Pagina 3